|
How much of your marketing budget do you waste each year? Perhaps tons! When you use a sheet that is an inch or two larger than needed, it can cost hundreds or even thousands of dollars. Millcrafts world class sheeting facility, Deltacraft, custom cuts paper to the exact sheet size you need, eliminating waste and saving you money! Deltacraft has the capacity to sheet roughly a hundred thousand tons per year. Equipped with one of the most accurate inventory control systems in the country, Deltacraft maintains an average of ten million dollars in roll inventory. Skids and cartons are made to accommodate any sheet size and count. Deltacraft Machines and Capabilities The Jagenberg Sheeter provides press ready skids from 40# uncoated offset, 50# coated offset, up to 24 point board. Cut off capabilities: 17 minimum, 64 maximum, roll width is 63 maximum. It can pull a 2 side trim while sheeting and slit 3 sheets from a roll, producing up to 120 tons per day. The New Milltex Sheeter provides press ready skids from 40# uncoated offset, 50# coated offset, up to 24 point board. Cut off capabilities: 12 minimum, 63 maximum, roll width is 65 maximum. The Milltex can pull a 2 side trim while sheeting and slit 4 sheets per roll, producing up to 120 tons per day. Deltacraft installed the new, state-of-the-art Milltex on August 1, 2005. The Clark Aiken Sheeter provides press ready skids from 10 point uncoated and C1S board, up to 32 point board. |
Cut off capabilities: 24.75 minimum, 78 maximum, with a 64 maximum roll width. Capable of economically manufacturing runs as short as a single parent roll, the Clark Aiken produces 192 tons per day.
The Seybold Guillotine Trimmer is great for short runs or heavy weight
board where the parent roll widths do not match the finish sheet size.
The trimmer is 100 in width, cutting sheets as large as 54 x 78. |
||